PLUS shower seat 310, fixed height

The shower seat is used to sit on during showering.
Expected service life of the shower seat is 10 years, provided that maintenance is carried out as described in the instructions for use (OMM).

The seat can fold up when not in use or to maximize floor space.

Ergonomically designed seat - contact surface are 12.2" x 14.4". Soft and slip-resistant material that has a warm feel.

Maximum user mass: 440 lbs.
When the seat is loaded with 440 lbs, each wall fastener is loaded with 187 lbs.

The seat has been tested statically with safety factor 1.5, which is a requirement according to the applied assistive products standards.

Pressalit makes a commitment to remedy material and manufacturing defects for a period of five years from the invoicing date.

This product is in compliance with all relevant requirements of regulation (EU) 2017/745 on medical devices.

The shower seat is made of polyurethane (PU) foam with a plywood core and this is covered with a moulded coated surface that is protected using a clear PU lacquer. Internal components and fasteners are primarily made of stainless steel. The hinge barrel is capped with ABS.

This product should be cleaned with hot water or a mild cleaning solution.
Do not use chlorine based, corrosive or abrasive cleaners as it may result in the surface being damaged.

The following cleaning agents have been tested by Pressalit and may be used, as long as they are diluted according to the instructions on the container.

DISINFECTANTS:
Erisan OXY+
Tvättsprit 70%
CaviCide surface disinfectant decontaminant cleaner
Rodalon Desinfektionsspray
Terralin protect (SCHÜLKE+)
Dismonzon Plus (BODE Chemie GmbH)

NON-DISINFECTANTS:
Wetrok Caledor (Wetrok)
Petrosol Citro (Büfa)

Important: Polyurethane surfaces of PLUS shower seats and PLUS backrests contains an antibacterial surface, which will be compromised if cleaned with anything other than soap and water.

The product must be wiped down with a soft rag wrung out in clear water immediately after cleaning, as some materials may otherwise be discolored and stained, and the surface coating may deteriorate.

DECALCIFICATION OF ALUMINUM PARTS:
Pressalit recommends that water deposits (Calcium, lime etc.) be removed from wall tracks and other aluminum parts using a solution of three parts of 30% acetic acid to seven parts tap water. When the aluminum parts have been washed down with this solution, the parts should be wiped over with a damp cloth wrung out in plain water.

Excl. mounting kit. See Technical specifications (pdf) for information on mounting kits suitable for various wall types.